Rpm Activated module installl ...Question

JdmTc · #1 (**permalink**) Sun., Oct 14, 2007

Does anyone know the color and location of the tach signal wire ...i have to tap into to wire my rpm activated module ?

navylife59 · #2 (**permalink**) Mon., Oct 15, 2007

RPM signal circuit
Camshaft position and crankshaft position are detected by the camshaft position sensor and crankshaft position sensor. Camshaft position is input as a control signal to TERMINAL G2+ of the engine control module, and engine RPM is input into TERMINAL NE+.

The Tach signal is fed to the black wire at pin 9 on the DLC3 connector aka CAN port aka OBDII port.

rpm-activated-module-installl-question-tach-signal-wire.jpg

rpm-activated-module-installl-question-j4-j5-junction-connector.jpg J5 Junction Connector.jpg
Views: 41
Size: 44.2 KB
ID: 839

rpm-activated-module-installl-question-tach-signal-figure.jpg

rpm-activated-module-installl-question-tach-waveform.jpg

JdmTc · #3 (**permalink**) Tue., Oct 16, 2007

Sweet just what i was looking for .. Thanx...

navylife59 · #4 (**permalink**) Thu., Oct 18, 2007

We are here to help.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)