Crank Pulley Removal/Install

[navylife59]

REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE FRONT FENDER APRON SEAL RH
(a) Remove the 2 screws, 3 clips and apron seal.
3. REMOVE FAN AND GENERATOR V BELT


REMOVE CRANKSHAFT PULLEY
(a) Using SST, fix the pulley and loosen the pulley bolt. SST 09213-54015 (91651-60855), 09330-00021


Using SST and the pulley bolt, remove the crankshaft pulley.
SST 09950-50013 (09951-05010, 09952-05010, 09953-05020, 09954-05021)


Installation is the reverse of the above procedures
INSTALL CRANKSHAFT PULLEY

(a) Using SST, fix the pulley in place and tighten the bolt. SST 09213-54015 (91651-60855), 09330-00021
Torque: 180 N*m (1,835 kgf*cm, 133 ft.*lbf)

UTILIZE THIS METHOD FOR TRD S/C
Clean and coat the threads of the TRD Hi-Strength 12-Point Bolt with Red Loctite 272
Thread Locking Compound or equivalent. Install into crankshaft pulley. Using the SSTs
and a 1/2 inch drive TORQUE WRENCH.
Torque to 150 ft-lbs.