Removal Of Sideview Mirror

[navylife59]

MIRROR – OUTER REAR VIEW MIRROR

REMOVAL
HINT:
• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.
CAUTION:
If the mirror shatters during disassembly, flying debris may cause injuries. Be sure to wear protective clothing, gloves, glasses, etc. when performing these procedures.
NOTICE:
When replacing the mirror body, prevent damage to the
mirror body by placing a protective cloth on the work
area.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
3. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
(a) Disconnect the connector.
(b) Remove the 3 nuts and mirror.


DISASSEMBLY
CAUTION:
If the mirror shatters during removal, flying debris may cause injuries. Be sure to wear protective clothing, gloves, glasses, etc. when performing these procedures.
NOTICE:
When replacing the mirror body, prevent damage to the mirror body by placing a protective cloth on the work area.
1. DISCONNECT MIRROR
(a) Face the mirror holder upward and look at the bottom of the mirror. Find the 2 grooves between the mirror holder and holder base. Insert a screwdriver into a groove and twist it to release the claw. Then repeat for the other groove.

HINT:
Tape the screwdriver tip before use.
CAUTION:

To prevent the mirror from shattering and causing flying debris, apply tape to the front of the mirror.
NOTICE:
To prevent damage to the vehicle, apply protective tape on the mirror holder base near the lower edge of the mirror. A piece of cloth can also be used.
(b) Lift up the lower part of the mirror holder and then release the 2 hooks on the top of the mirror.
(c) Remove the mirror holder.
2. REMOVE MIRROR GARNISH

(a) Detach the 7 claws.
(b) Remove the garnish.
3. REMOVE SIDE TURN SIGNAL LIGHT LENS LH

(a) Disconnect the connector.
(b) Remove the 2 screws and lens.