Is that possible?

[midnightct]

Is there any way to make a AT car to MT..? Is that Possible and how much do it worth..? Please answer my question please... i m tired of AT..

[JRW-910]

Well, anything is possible. It really comes down to what such a transformation is worth. Speaking in general terms as I have never done such a conversion on a tC, you need to consider so many different things from rear end gearing, drive shaft length, dash bezel around the shifter, etc etc.

IMO, its not worth it at all. I'd sell the automatic car and simple buy a manual and start building from there.... unless you can pick up all the parts cheaply and do all of the work yourself... then, good luck with it!!

-JRW

[navylife59]

If your talking about the tC, you need an AT ECM, possible harness adaptor, pedals, shifter, shifter cables, a different master cylinder. Axles should be the same. As JRW stated, it is very cost prohibitive. You would be able to to do rather easily. If you are lucky, you might find a MT tC being parted out.

[StreetracerJay]

Well if you are going to do it good luck. Its going to be a lot of work. What year is your tc?

[midnightct]

mine is 08... just wondering how much will it cost lol..

[navylife59]

Contact Ken or Jamie at TRD Sparks and have them cross-reference the parts I listed above to see if there is a difference between part numbers for auto/man.

[midnightct]

how to contract them..?

[midnightct]

i want to trade in for an MT .. but i already put 4 new spring and rims and navi on my car....and i sold the original one... and i put hid ... and greddy ti-c exhaust muffler... thats why i dun want to trade in for in cause the car dun worth a lot after i change all these things... thats why i m finding a way to make a AT car to MT... will it cost over 5000$ if i want to do it?

[navylife59]

TRD Toyota/Scion Parts Accessories from Sparks Toyota/Scion

Cost all depends on whether you can buy a used transmission and if you do your own labor. I would think that you could do the work yourself for under $2.5K.

[midnightct]

what if i do it out side? the labor cost a lot?

[navylife59]

It all depends on how much the shop charges, how much custom fab work, and how much time the shop will have to research the swap.

[midnightct]

oic..i think i can;t do anything now.. hah... someone just rush my car...

[hotrice]

why didn't you just get a manual in the first place??