Registration is FREE and takes seconds to complete!
Club-tC Members Receive:
? Advertisement Free Browsing
? Access to all tC Tech Articles
? Ability to post questions and comments
? Use of private message system
? Ability to share images
? Their own personal profile page
? More tC information then anywhere else
Sign Up Now!

Power steering help

Discussion in 'Suspension & Brakes' started by Sciontc4life05, Jun 8, 2020.

  1. Sciontc4life05
    Offline

    Sciontc4life05 New Member

    Joined:
    Jun 8, 2020
    I replaced my pump, tensioner, belt, and the car wanted to stall when turning. So i replaced the power steering pressure switch. Same issue still. I looked for a pin out for my 2005 scion tc, and it says E6-10 R, but i don't have a wire going to that spot.

    I forgot to remove the connector when trying to remove the pump so it got some stress on the connector and wire. Not sure what to do from here.
     
    Last edited: Jun 8, 2020
  2. Sciontc4life05
    Offline

    Sciontc4life05 New Member

    Joined:
    Jun 8, 2020
    Not sure if this info helps or not, but when i took the car for a test drive about 1 mile it only wants to stall at stop signs, and in my driveway it will stall. Strange part is the wheels had been striaght, and i was waiting on the garage door to open when it stalled.

    I am just assuming its the wire, but no check engine light is on.

    Just took it to the garage to have them look at it.
     
    Last edited: Jun 8, 2020
  3. Sciontc4life05
    Offline

    Sciontc4life05 New Member

    Joined:
    Jun 8, 2020
    Turned out my throttle position sensor needed reprogrammed
     

Share This Page