Rear lowering spring install

I have a set of Drop Zone springs I am dieing to get in. I know how to do the fronts but the rears I will have a problem with. So does anyone have pictures and/or instructions to help me. I don't want to start taking stuff off and be screwed not being able to get it back on. The other thing is would i require a spring compressor or would I be able to get the springs off with out killing myself, lol? Thanks for any help.

Yeah you're gonna need a spring compressor. Always use a spring compressor. Always. Better safe than sorry!

Other than that, you'll need to remove a majority of the interior panels in the trunk.

Other than that its just like the front.

Thanks. How far forward do i need to remove the panels??

Hmmmm I haven't done my tc yet, and last tc I did was about 1.5 years ago, but I do remember removing the carpet, the side carpet, and I think any trim up to the rear seat. I can't be for sure without looking, and it being 12:40 am by me I'm not making a special trip outside from my bed lol!

The whole r&i is not difficult at all. Anything you remove has a special place and won't fit any other way. As far as special instructions go, just don't lose any panel clips cuz then pieces will end up being loose upon reinstallation.

Thanks, yeah I learned my lesson when I put the CAI in and a few clips disappeared.

isnt there an article here on springs installation?

whaddya know??? Scion tC Forums - Rear Spring & Shock Installation

this is what you're lookin for right?

OK good there is already one. I took pictures and everything to post a how to... too late, it is all done now. Thanks for looking for that. Lowering it makes it look totally different..definitely pleased....thanks again for the help..