Registration is FREE and takes seconds to complete!
Club-tC Members Receive:
? Advertisement Free Browsing
? Access to all tC Tech Articles
? Ability to post questions and comments
? Use of private message system
? Ability to share images
? Their own personal profile page
? More tC information then anywhere else
Sign Up Now!

Strut Bar Installation

Discussion in 'Suspension' started by Alex8181, Feb 19, 2006.

Thread Status:
Not open for further replies.
  1. Alex8181
    Offline

    Alex8181 Administrator

    Joined:
    May 16, 2005
    Location:
    2005 Flint Mica
    Written By: Alex8181

    Difficulty (1-5): 3
    Time Frame: 45 Minutes

    This install in particular is with a DC Sports strut bar. Should be very similar with other bars.

    Step 1: The first step is to remove four plastic plugs that hold the cowl covering the suspension. There are two on each side.

    1.jpg

    Step 2: Now unscrew the nuts holding the suspension with a 14mm wrench. Do not remove the third nut that is closest to the fenders (the ones that are farthest left and farthest right).

    2.jpg

    Step 3: Now lift the car so the wheels are off the ground. If you had left one of the bolts on the suspension bolts should still be peeking through the top of the suspension tower.

    3.jpg

    Step 4: Manuever the strut bar into place. Screw the nuts back on by hand to hold the strut bar in place.

    4.jpg

    Step 5: Drop the car to the ground and tighten all the bolts. Torque to 38 ft. lbs. Re-install the plastic plugs for the cowl and you're done.

    5.jpg
     
Thread Status:
Not open for further replies.

Share This Page