Registration is FREE and takes seconds to complete!
Club-tC Members Receive:
? Advertisement Free Browsing
? Access to all tC Tech Articles
? Ability to post questions and comments
? Use of private message system
? Ability to share images
? Their own personal profile page
? More tC information then anywhere else
Sign Up Now!

Tach Signal Location

Discussion in 'Engine' started by navylife59, Oct 15, 2007.

  1. navylife59
    Offline

    navylife59 Super Moderator Staff Member

    Joined:
    Mar 22, 2006
    Location:
    Emory, Texas or Gretna, LA
    For those in need of the tach signal, here is where you can access it.

    RPM signal circuit
    Camshaft position and crankshaft position are detected by the camshaft position sensor and crankshaft position sensor. Camshaft position is input as a control signal to TERMINAL G2+ of the engine control module, and engine RPM is input into TERMINAL NE+.

    2007~2008 Tach signal is fed to the black wire at pin 9 on the DLC3 connector aka CAN port aka OBDII port.

    Note: 2005~2006 tC's do not have pins 6 and 14 populated. That means a CAN only diagnostic port sensor reader, like the MSD Dashhawk, will not work. Check with manufacturer about this compatibility before you purchase the others available on the market, ie Greddy, Blitz, HKS, etc.

    View attachment DLC3 Connector.bmp

    View attachment DLC3 Pinout.bmp

    Tach Pinout 2007-Up tC ECM.jpg
    Note: This is for 2007~Up tC only!

    Tach Signal Figure.jpg
    Note: This is for 2005~2006 tC only!

    Tach Signal Wire.jpg

    Tach Waveform.jpg
     

Share This Page